This week we focused on framing into our timber shed the door RO and getting started on our roof rafters. In this first set of photos you can see the half lap joints we cut into the vertical stud members for the door to fasten to.
Here you can see the door opening. 
Here you can see the tongue and fork joinery for the rafters. We begin by cutting everything on the ground and carry them into place. Then we plum the rafters and begin to edit the joinery down at the birds mouth/ seat cut. At that point we can establish a beautiful joint from the rafters to the top bent plate and girder. Which can be seen in the photos below.
 |
| Almost done! |
0 comments:
Post a Comment